Home>>partial replacement of fine aggregate with dust


partial replacement of fine aggregate with dust

Strength Properties of Concrete with Partial Replacement

produced with red granite dust as a partial fine aggregate replacement. [3] The experimental test results showed that the use of granite dust at 20 to 50% level reduces significantly the concrete compressive strength and had little negative effects on concrete tensile strength.

EXPERIMENTAL STUDY ON PARTIAL REPLACEMENT OF FINE

4.1.3 Mix Proportion Experimental Study on Partial replacement of fine aggregate with Sawdust and Quarry dust. In this study the Notation Quarry dust Saw dust Natural sand effect of quarry dust and sawdust, by adding 10%,15% and M0 0% 0% 100% 20% with the

IRJETExperimental Study on Partial Replacement of Fine

In preparing concrete fine aggregate is partially replaced by quarry dust and saw dust the present investigation has been under taken to study the effect of sawdust and quarry dust, by adding

Experimental Study on Concrete by Partial Replacement of

The Glass Powder is used as 20% replace by weight of cement and Stone Dust as the partial replacement of Fine Aggregate from 0%, 10%, 20%, 30% and 40%. The grade of

Can we make concrete by partial replacement of fine

·

Yes you can replace some amount of fine aggregate with quarry dust but before adding the quarry dust you should follow some guideline's. Avoid addition of quarry dust if have no experience or little experience in concrete technology. Use only after consulting with professional engineer

() Stone Dust in Concrete: Effect on Compressive Strength

·

Experimental programme was conducted using 30%, 40%, 50%, 60% and 70% partial replacement of fine aggregate with stone dust has been taken for concrete of M25 grade with 0.46 water cement ratio.

Experimental Study on Partial Replacement of Fine

conventional concrete and replacement concrete (quarry dust + red soil) was prepared by replacement of fine aggregate with for 20%, 30%, 40% and 50%. The samples were categorized by age of the concrete at the day of testing, quarry dust and red soil content. For each mix, 3 cubes were tested for compressive

EXPERIMENTAL STUDY ON CEMENT BRICK WITH PARTIAL

Thus the experimental investigation on partial replacement of fine aggregate by saw dust and quarry dust has been done. As the natural sand is replaced by saw dust and quarry dust the usage of sand is reasonably reduced in the environment and saw dust and quarry dust is effectively used. Results of experiments on compressive strength, water

Effect on Partial Replacement of Fine Aggregate and Cement

Also cubes of (1:3) mortar with partial replacement of sand with the same amount of WMP Granules were casted and their strength was evaluated after 7, 14, and 28 days in different lots. Their results were compared with those of standard (1:3) mortar and concrete cubes. II.

:IOSR Journal of Mechanical and Civil Engineering · 2014:Ris Hi · Vanita Aggarwal

Study of Concrete Involving Use of Quarry dust as Partial

facing. In this paper, the issues of environmental and economic concern are addressed by the use of quarry dust as partial replacement of fine aggregates in concrete. Fine aggregates were replaced by quarry dust as 0%, 10%, 20%, 30% and 40% by weight for M-25 mix. The concrete specimens were tested for compressive strength,

EXPERIMENTAL STUDY ON PARTIAL REPLACEMENT OF

In this present investigation is to study the effect of partial replacement of coarse aggregate by bamboo with 5, 10, 15, 20 and 25% and fine aggregate by quarry dust with 15, 20,25% respectively. The effect of replacement of bamboo and quarry dust was studied using basic

STUDY ON STRENGTH AND DURABILITY OF CONCRETE BY

efficient disposal. Hence, partial or full replacement of fine aggregates by the other compatible materials like sintered fly ash, crushed rock dust, quarry dust, glass powder, recycled concrete dust, and others are being researched from past two decades, in view of conserving the ecological balance.

() Stone Dust in Concrete: Effect on Compressive Strength

·

Stone Dust in Concrete: Effect on Compressive Strength. Workability and Compressive strength were determined at different replacement level of fine aggregate viz a viz referral concrete and optimum replacement level was determined based on compressive strength. Results showed that by replacing 60% of fine aggregate with stone dust concrete

Review on Use of Stone Dust as a Partial Replacement of

made by partial or full replacement of river sand by crushed stone dust as fine aggregate and reported that 40 percent sand can be replaced by crushed stone dust without effecting the strength of concrete. (1999) Hudson reported that, ''concrete manufactured with a high percentage of minus 75 micron material will yield a

What are the advantages of using quarry dust as fine

·

May 22, 2017· From the results of experimental investigations conducted, it is concluded that the quarry dust can be used as a replacement for fine aggregate. It is found that 40% replacement of fine aggregate by quarry dust gives maximum result in strength than normal concrete and then decreases from 50%.

Can we use quarry dust in place of sand for road construction?Jul 03, 2018What are the advantages and disadvantages of stone dust in Nov 07, 2017Can we make concrete using quarry dust as a replacement Jun 30, 2017I am using quarry dust (fine like cement) as a partial May 28, 2017

EXPERIMENTAL STUDY ON CEMENT BRICK WITH PARTIAL

Thus the experimental investigation on partial replacement of fine aggregate by saw dust and quarry dust has been done. As the natural sand is replaced by saw dust and quarry dust the usage of sand is reasonably reduced in the environment and saw dust and quarry dust is effectively used. Results of experiments on compressive strength, water

Partial Replacement Of Fine Aggregate By academia.edu

The properties of concretes glass dust waste as fine aggregate were investigated in this study. Glass dust waste was used as a partial replacement for sand at 10%, 20% and 30% of concrete mixes. Compression strength for 7, 14 and 28 days concrete of age were compared with those of concrete made with natural fine aggregates.

Study on Compressive Strength of Quarry Dust as Fine

From the results of experimental investigations conducted, it is concluded that the quarry dust can be used as a replacement for fine aggregate. It is found that 40% replacement of fine aggregate by quarry dust gives maximum result in strength than normal concrete and then decreases from 50%.

Project on Partial Replacement of Cement with Marble Powder

This project describes the feasibility of using the marble sludge dust in concrete production as partial replacement of cement. In INDIA, the marble and granite stone processing is one of the most thriving industry the effects if varying marble dust contents on the physical and mechanical properties of fresh and hardened concrete have been investigated.

Experimental Study on Partial Replacement of Fine

conventional concrete and replacement concrete (quarry dust + red soil) was prepared by replacement of fine aggregate with for 20%, 30%, 40% and 50%. The samples were categorized by age of the concrete at the day of testing, quarry dust and red soil content. For each mix, 3 cubes were tested for compressive

Partial Replacement of Fine Aggregates with Quarry Dust

International Journal of Engineering Trends and Applications (IJETA) Volume 5 Issue 3, May-Jun 2018 ISSN: 2393-9516 Page 57 Partial Replacement of Fine Aggregates with Quarry Dust and Marble Powder in Concrete

EXPERMENAL STUDIES ON M20 GRADE CONCRETE BY

fines as a replacement of fine aggregate in 6 different proportions namely 0%, 10%, 20%, 30%, 40% and 50%. The test results indicate that granite powder as replacement fine aggregate has beneficial effect on the mechanical durability properties such as compressive strength, split tensile strength and

Partial Replacement of Cement with Marble Dust and Fine

Experimental programme was conducted using 30%, 40%, 50%, 60% and 70% partial replacement of fine aggregate with stone dust has been taken for concrete of M30 grade with 0.46 water cement ratio. In this study, set of cubes and beams were cast for compressive and split tensile strength respectively.

STUDY OF PARTIAL REPLACEMENT OF FINE AGGREGATE BY

with quarry dust as a partial replacement of fine a ggregate, the following conclusion can be drawn: 1. The compressive strength of concrete is i use of quarry dust up to 10% replacement of sand. F rom 10% there is decrease in compressive strength 2. The split tensile strength concrete is increased by the use

GGBS and Fine Aggregate with Quarry Dust Concrete by

Abstract: In the present study an investigation is made on properties of concrete by partial replacement of Cement with Ground Granulated Blast Furnace Slag (GGBS) and Fine Aggregate with Quarry Dust (QD). Ground Granulated Blast Furnace Slag is a by-product of Iron and Steel industry which is produced in large quantities as a solid waste.